Flow NX2 Carbon Fusion Size Question?

Posted by: @daniel-pesch

↑

And are these 2 binding offers the same?

... according to Wikipedia Nidecker Group (Switzerland) did the takeover of Flow (USA) in 2017, so yes, they are the same.

Posted by: @daniel-pesch

↑

Should I get the smaller or the larger binding?

I use the 2024 NX2 Carbon in size L in combination with a Deeluxe - Deemon EU42/US8 boot and the overhang on the tip/toes (boot tip to binding toe edge) is aprox. ~ 3 cm. This distance seems quite large, but more details of fitting you find here.

Open Letter to Flow Binding Co

... but I assume you will need the XL binding with your boot size

@vospegmx-at OK, I have the Deeluxe IDxHC BOA FOCUS, EU 44, Mondo 29.

This Size is the last one of the Size L.

Thanks

My wife rides in an M26 boot and uses the Large CX, I ride in M29's and ride in the XL's.  Even with the L's, she often struggles to get in and out of the binding and tends to use it as a three strap binding (unlatch the highback, then loosen the fusion buckles), which kind of negates the whole Flow idea.  

Here is my 29.0 boot in my wife's L NX2.  Doable, but pretty snug.  I didn't want to change all her settings, so the highback wouldn't snap closed.  

because I was adjusting my binding setup the last days to center the NX2 on the C4 without the donek riser plate I used before, I like to point out the hidden mounting point at the baseplate of the binding. 

see: https://carversconnection.com/community/postid/324/

Otherwise I was not able to center the boot (Deelux Deemon EU42/US9). It is essential to do the mounting of cable and highback on the red or blue position, standard is blue, but for my boot I had to chose the red position

in my point of view a perfect result

and I can theoratically tilt my board 89° on the heelside, on the toeside it is >90°