@wild-cherry I'm not sure if my thought will be accurate in translation, but I'll try to convey it accurately. With a larger positive mounting angle, ...

Here’s a good vid to start with: I’ve summarized it in this table. Your natural stance is the height to the centre of your knee cap, and you move o...

That’ll certainly ruffle some feathers! While I don’t always agree with you, I do truly appreciate what you’re doing. I think it's been like 25 yea...

I had to figure it out at a time where the only information available was in the manufacturers catalogs... What board are your riding? How much do ...

You'll have three stiffness options and the inserts can be set for your stance exactly so it's easier to turn your disks 90 degrees to centre your boo...

Hey @solorider, That's a lot of overhang! It's going to be tough to carve that setup for sure.= You can get riders from jayeyjay.com. We'll ha...

Yeah, I was thinking about that type of carve as well. I see that video is 2 years old. Maybe in 2 years I can also lay out over the snow in my carves...

Not sure of an exact formula for stance width. My inseam length is about 79cm and my stance width is the same as yours, 56cm. Sometimes 55cm on smal...

On the front I put the pivot all the way up, you can measure up from the board to see what’s the highest (there’s only like 5mm of vertical difference...

@board-doctor Hello. On models ROME you are using the top strap mounting lever rotation?I'm asking this question because I have the same problems. I ...

What sort of changes could be made to the board? Could it be narrowed?

There’s the Korua Trench digger and Pencil, so I’d scratch those names. I think cherry is cool, could even just have a subtle 🍒 graphic garn...

@flyguy I think you might be confusing me with James… though we do kinda look like brothers from another mother 😂 (I don’t have the flow bindi...

@firefighter I’ve got a boney instep, so pain and redness if it’s not dialed in. Boots can be a bitch. I mainly have Rome on my powder & all mou...