Binding mods… Personally I prefer my high backs to have a little bit of flex, so not the stiffest. Also rotated parallel to the board, partially fo...

@wild-cherry I apologize for the off-topic, but it’s like a group Joy Division 🙂 🙂 And on topic - in an hour and a half I will be o...

@deuxdiesel , i like that one. The Other Woman.

there is the option to make the bindings a little bit stiffer if you change the straps and the highbacks. However the options are limited

This probably isn’t the answer that you’re looking for, but I rode a friend’s old Sims switch blade until ‘97. It was a bit large for me, maybe a 162...

Still waiting for my new Thirst to show up at my front door!

Many companies named their soft boot carver with X, like Oxess named CX, virus and Kessler named x carve, so way not just names this board the “JX” to...

You need to bring your left hand down closer to your front knee, and stop reaching for the snow with your right hand. This will level up your shoulder...

So I just got both Deeluxe Heel Harness Pros delivered and gladly found out that each purchase comes in pairs. I was going to post an update tomorrow ...

I like to finish my toeside like this guy so that my hip shift at the transition is more lateral. From:/p>

My guess is the pendulum effect of the up-unweighted turn put your centre of mass too far out from the board and your weight wasn’t stacked over the e...

Just put down a deposit. Really looking forward to this. I’ve been riding a couple of different Virus boards (Avalanche 160, 168, and a Revolution 163...

It's certainly intriguing (I had never measured the outter length of my boot before), but I think if you took 20 mm out of the width I'd probably stil...

I think I see what you mean about the quick slashing type carves. I am able to do those pretty well on my board as well. But from your video, I guess ...