Posted this on the alpine forum as well. I've figured out what my issue was. After a few doctor appointments, PT, and conspiring with other car...

I'm not sure how those boots lasted so long! I had Ride insanos previously. It was a good boot while it lasted. Stiff and very low profile. Didn't l...

@evilofrex Something like that. I honestly don't know. They just ended up where it felt best with the canted risers. It was hard to measure the angle ...

@justin-doan Thank you! Loving the new board.

Instead of choosing a width determined by your mondo point size, I would focus on the actual length of your setup. Measure with the binding and boot o...

Welcome to the forum! In my opinion, this setup will not be too much for you. Korua boards are a good starting point for carving. They don't compar...

@damir The Kessler x carve had slightly better hold on ice. On good snow, they felt similar. I would get a lot of chatter on the X carve but not so ...

You should have no issues. James also has the smaller variant of the board if you haven't seen it. Here are some clips from the first day on the C4. I...

Upon first unboxing the C4, I was immediately impressed. At first glance, I fell in love with the aesthetics of the board. The matte black topsheet wi...

@dan Do you get those replaced under warranty? If you still have a broken set I'd love to get my hands on them. I could TIG weld them back together an...

I'm not a guru, but I will explain what helped me carve steeper slopes. I found on steep runs I really had to mitigate my speed to stay in control....

@ronaldb I think you might want that 171 extra wide 305 waist red prototype board James is going to list for sale. But I think he said he wants a regu...

Been running these Trenched BX risers. They work as intended, stout hardware, and look good 😎 excited to try the canted risers.

The C4s for sale are all of titanal construction. I don't think any of the fiberglass proto boards are for sale yet.