@shrekonboard yes but if the highback goes a little bit back, MAYBE the boot could also get e littile bit more towards heelside, and will be better po...

the highbacks are not so gut adjusted. Maybe if you put the highbacks one hole higher, and the cables one hole back it will be better Otherwise...

there is the option to make the bindings a little bit stiffer if you change the straps and the highbacks. However the options are limited

i am not an expert for +/+ but i think that you upper body was not in the right position (0.28) and then the balance was lost

indeed. but also important is how wide is the board. A board with WW from 27.5 and over, need another set up as a board with WW 26.0

where could the Deeluxe Heel Harness help? for ankle support or will make the liners a little bit stiffer?

@board-doctor i am also not sooo flexible. I do not board like Knapton, at least the heel side turn are normal carving turns, and not lay down as some...

first of all you have to find the boots. Be sure which is your MP, and then look for the boots. Then you have to find the combination bindings + boa...

@wild-cherry ok, that makes me worries. I wanted also the DriverX in 9, to combine them with the liners which i have (from Adidas). But if the Drive...

i have only one board, X-Wide and i am also with duckstance. Although not +15/-15 i preffer the +21/-9 However i am still trying to optimize my tech...

@xargo yes indeed. In this photos the hip rotation is more obvious. Nice....

not an expert but according to your videos e.g. at 0.28 you make a more "upper body" rotation instead of hip rotation. But I dont think that a bigg...

i have adidas 27.5 with L Flow Fusion Hybrid and i think they are ok. What boots do you have? Burton?

Line Drawer, or Line Driver

Well, i would like to know if they even reply to your Open Letter. I ordered some spare parts for my bindings, they delivered only 1 from the 4 i o...