I had this issue for one season, my mostly in the front foot but some in the back foot too. Then I stopped riding Flux XV bindings and the problem w...

Right on! What does your current setup look like? Angles, stance width, bindings, boots? Forward lean? You have a set of the Butterfly Wing BX R...

Probably. It's 260mm minimum width underfoot, you will have to measure the board width under your back foot inserts. It's also possible to shave 2-3...

My design already has some small wings built in. I'm planning to test out Jasey's lateral boot stiffener soon and go from there. I might like it a l...

@slabber You should hold on to those. Your new boots will break in fast and you'll probably want to add stiffness later. Plus, in the future too as ...

@smann Hey! Welcome to the forum! Not by chance, but I do have a tape measure... 169cm overall length, 141cm effective, 321mm tail, 290mm waist, ...

Are you sure about that? If that's true and the SP Mountain is the same as the Gnu, I'm not interested. The GNU is super soft.

I can do $300 shipped to Quebec if you pay by e-transfer. I can send a single canted riser for your back foot and pair it with a flat Butterfly Wing ...

Yeah, kind of true... I'm not saying that NeverSummer makes great carving boards, just that their boards carve well enough to serve as great all...

Have you seen (or hand flexed) the SP Mountain Multientry? That one might have potential. No other rear entry binding I've seen comes close to the F...

@flyguy No, no benefit of wider boards besides boot out prevention. Remember though that when you're carving hard on steeps a hair of underhang is n...

Feels a bit narrow sometimes for my 8.5s... I'm using risers too. What the heck else would you be doing with it? Stick with it man, this is th...

Pressure the board on the edge directly in front of your front heel when chatter starts on heelside carves. How much for the kidney? Is is r...